Software
Houzz Logo Print
indecent_cracker

Z-Wave three way wiring

11 years ago
last modified: 11 years ago

Me and the wife recently purchased a GE (Jasco) Z-wave three way switch. Our first Z-Wave so far, so we're still new to the whole thing.

After receiving the switches in the mail, I realize our current wiring does not match what the instructions say is typical.

According to the instructions, power should go from the breaker, to primary, to accessory, to light.

I can't tell which switch currently is primary, if either, as they both have power at all times.

The switch at the bottom of the staircase has a red, white, and black wire (and ground). With no wire bundles in the back.

The switch at the top has the same red, white, and black (and ground). But with a black and white wire tied together in the back.

I can't even figure out whats going on in there now, let alone how to wire up these Z-Wave switches. Any help would be appreciated. I've tried finding a guide for my situation, but everything I've come across refer to wiring that I apparently do not have.


Edit: A shot of each switch. Sorry for the bad angles, my phone's screen broke, so I had to take these blind.

Upstairs


Downstairs

Comments (6)

  • 11 years ago

    But with a black and white wire tied together in the back.

    From the same cable? Seems weird, but maybe it has nothing to do with this circuit.


    Your wiring is probably set up this way:


    I have no idea what Z-wave is, so I can't help you on how to hook that up but hopefully if you understand what you have, then you can figure out where you have to go.

  • 11 years ago
    last modified: 11 years ago

    Hmm, assuming that black and white twisted together don't relate to the light, that diagram would make sense. I'll have to investigate those two wires more when I'm home. Thanks.

    Edit: Z-Wave is one of the home automation systems. And from their instructions that whole breaker->primary->accessory->light setup makes me think that if I have a 'power to light' setup, I'm going to have to rewire the whole thing. Since even if you swap the primary/accessory order, the light won't work.

    Even the simplest projects become a nightmare...

  • 11 years ago

    Shoot, I think you're right. Looking at Youtube videos the guy has the three wires to the switches (two blacks and a red) and whites tucked in the back. I have nothing tucked away...

    Looking like I either need to give up on Z-Wave, or completely rewire...

  • 11 years ago

    Can you get to the light? It might be informative to see the wiring there as well.

    My guess is that that black/white pair that are tied together is the original switch loop (it was there for a single switch) and it was 'retired' when the light was made 3-way. If power goes into the light like the first diagram, you'll be fine.

    Also, you have black/white/red at both switches rather than white/white/red and black/white/red.

  • PRO
    11 years ago

    accepting that high contrast bent together don't identify with the light, that outline would bode well.

Sponsored
Kuhns Contracting, Inc.
Average rating: 5 out of 5 stars26 Reviews
Central Ohio's Trusted Home Remodeler Specializing in Kitchens & Baths