Software
Houzz Logo Print
billy_harrisjr

Smoke detector chirping problem even with no power

10 years ago

two smoke detectors in and near the bedroom each one taking turns chirping every thirty seconds. We removed the detectors (which were not wired to any CO2 system or security system), pulled out the batteries, flipped all the power breakers to the house. Now we're sitting in the dark with a flashlight under the wiring box for the smoke detectors and they are still chirping. Not the detectors, which are in the basement two floors away sitting there without batteries. The wiring boxes are chirping. Any ideas?

Comments (10)

  • 10 years ago

    They will chirp for a while after the battery is gone. Think about it. What's the difference between a dead battery and a gone battery?

    Try putting fresh batteries (and don't use the Lowe's Utilitech batteries, I got a brick of those for my smoke detectors and half were already dead) in.


  • 10 years ago

    The wiring boxes are chirping.

    The boxes with just the wire termination in it? Or is there a base for the detectors to connect to that contains some electrical components?

    If it's just the former, then I'd say your beeping is coming from somewhere else.

    A picture might help.

  • 10 years ago
    last modified: 10 years ago

    Agree about chirping coming from elsewhere, maybe detector in a nearby room?

    ETA. We used to have the same happen to us until DH decided to change ALL batteries at the same time, once any detector starts chirping--he just changed them all right then.

  • 10 years ago

    I agree with Bossy. Once one starts, you might as well just do them all. It will save the time finding which one it is and the others will start going in a week anyhow.

    The one time I had a hell of a time finding the thing that was chirping was that there was on the floor a "water detector" and that thing had a battery that was going as well.


  • 10 years ago

    geoffrey

    That was cruel...

  • 10 years ago
    last modified: 10 years ago

    Smoke detectors typically have a small control board with some capacitors. There is enough leftover power in the capacitors once you take the battery out for it to chirp a few times. It will stop eventually. Or just replace the battery and it will stop also...

  • 10 years ago

    Vith: You can usually discharge those capacitors (even big ones) buy putting your tongue across the terminals.

  • 10 years ago

    True, very effective way. :)

  • 10 years ago

    Chirping - I would get some bird seed - possibility a mixture - so it will work on a wide variety of chirping detectors.

Sponsored
Landscape Management Group
Average rating: 4.9 out of 5 stars33 Reviews
High Quality Landscaping Services in Columbus