Software
Houzz Logo Print
main_office2

3 lights between two 3-way switches

8 years ago

I would like to wire three lights between two 3-way switches. Can you give me a diagram for this?

Thanks

TH

Comments (10)

  • 8 years ago

    Here's one with 2 lights between the switches. I'm sure you can figure out how to expand on it to make it three.



    main_office2 thanked greg_2015
  • 8 years ago

    Thanks Greg - I have similar diagrams but I am unsure how to wire third light.

  • 8 years ago
    last modified: 8 years ago

    The third light is connected to the same black, white and green/bare wires as the other two.

    There are multiple variations on installing three-way switch circuits, depending on where the line from the power source enters and how the cables are routed between devices. There are many resources online and in libraries that have diagrams to fit any scenario, but sometimes it's best to call an electrician.

  • 8 years ago

    Thanks Randy - I understand the B/W wires, it is the 3-way wires which I am unsure of. My application is as you state a different configuration, power coming in at one of the lights and splitting from there. I have rewired several of my homes always checking with people in the know and use published diagrams. I have looked everywhere for a diagram with 3-way switch and three lights and different configurations without success.

  • 8 years ago

    So the power is coming into the light? Details matter :)

    Here's another diagram:

    To connect 2 more lights, just extend the black and white connected to this light to the other lights.


  • 8 years ago

    Thanks - I think I have this now.

    If you see your lights dim... maybe not

  • 8 years ago

    Do you want all three lights controlled by the same switches - i.e. if one light comes on, all do? That's the simple case: the black wires are tied together, as are the white wires. If some of these lights have regular incandescent sockets, make sure the white wire goes to the outside, threaded bulb terminal and the black wire goes to the one in the center of the socket. If that's not the case, then you haven't given enough information as to what you want.

  • 8 years ago
    last modified: 8 years ago

    Location of power source is the most important detail, and where you start with any circuit.

  • 8 years ago

    Wow - good to know. I did not know that, I am adding additional lights to a three-way run I had installed 10+ years ago and fortunately had wired the 2-wires in the same access hole.