Software
Houzz Logo Print
geoffrey_shipton

Corrosion on fire sprinkler pipe

5 years ago

Hi all,

I have a sprinkler system in my house, the feed comes directly from the mains water supply via its own meter. I see a large (2 1/2") pipe coming into the house. My worry is corrosion of this pipe. I am wondering whether this large pipe is in fact the outside of the actual pipe or if it is just frost protection for a smaller pipe inside. The sprinkler pipework in the house is only 2" and the pipe at the meter looks to be 1". The pressure in the system is 75psi so a failure of this pipe could be a major problem.

Photos attached, I note a wire attached to the pipe at the water meter could this be for an anode?

Any thoughts are most welcome.

Geoff







Comments (6)

  • 5 years ago

    No one has responded so I'll tell you all I know from seeing sprinkler systems in commercial buildings. Sprinkler systems are usually installed in black iron piping like I see in your photos. Newer installations in houses often use plastic. However, black iron won't survive in direct contact with soil. If that's your main coming in, it doesn't look too good. I'm not sure what the preferred underground main pipe type should be: ductile iron? How old is your house? If you haven't had a sprinkler test done, maybe now is a good time. 2-1/2" may be right as the main. Commercial buildings I've seen start at 4". I rarely saw a meter on the fire main, as a meter cuts down flow, and there's no reason for one. However the municipality may have required it. The wire might be a ground for something.

  • 5 years ago

    Ok thank you, it does seem odd that there is this very large pipe fed from a much smaller one at the meter (it must be a requirement I guess - it always reads zero) and then smaller again in the actual building. Seems like asking for trouble, anyway I now have a key so I can shut it down at the meter if needed!

  • 5 years ago

    Often, the water supply line comes underground to the building, and splits underground, with domestic line going through a meter and the fire line is unmetered. You can verify if the sprinkler goes through the meter by turning off everything in the house and opening the test port on the sprinkler, and see if the meter moves.

  • 5 years ago

    or turn those valves at the meter to off and see if it affects the sprinkler flow at the test port.

  • 5 years ago

    Honestly, your system looks bad. You need to check the size of the pipe, how many inches and also I believe that you should replace the pipes with another material. As for the wire - I suspect it's ground for something.

  • 5 years ago
    last modified: 5 years ago

    In general, I found out the information you need.

    A friend of mine is working on this case and he told me that you need to change the pipes to a newer material. Apparently, your pipes last about 5 years and then they need to be changed.

    Your sprayer looks bad, a friend recommended choosing a quality sprayer as it is very important in such a situation. He showed me where to choose the best lawn sprinkler and if you want to choose yourself.

    As for the wire-there are two thoughts-this is either a ground that looks very bad, or it is the wire of an automatic sprayer, but yours looks like it does not have the ability to automate so I am more inclined to believe that this is a ground

Sponsored
Hope Restoration & General Contracting
Average rating: 4.7 out of 5 stars35 Reviews
Columbus Design-Build, Kitchen & Bath Remodeling, Historic Renovations