I'm using that stuff in my basement now. I'm using new construction lights and cutting a hole. I intend to lay out the grid such that the majority of the lights fall in the center of the tiles (for aesthetic reasons only).

When you install the new construction cans, does the 1/2 drop they have for the sheetrock match up with the panels, or do they need to drop more? Did you just plan your lights where you want them, and are matching the grids to them the best you can? How do you like the grids so far...good/bad?

I just did my ceiling with this type of mount (ceiling link...not ceiling max). I mounted the cans to the joists just like you would with drywall. I then cut the holes in the tiles that match the cans. The tile is a little lower than the can, but the trim ring makes up the difference.

Good luck.

Most of the housings for the recessed fixtures can be clipped to the T bar. Decide where you want the fixture, cut the hole, install the housing by extending the brackets to the T bar.

Can the brackets on the ceiling max system support recessed lights...I am not sure about that, I thought no.