Software
Houzz Logo Print
detroitreds19

Looking for feedback on adding LED lights to snow blower

11 years ago
last modified: 11 years ago


I have a snow blower that has the stock halogen bulb. I would like to disconnect that bulb and add 2 LED lights. I've gathered information and put them in a diagram. I'm looking for confirmation that I'm covered in that everything is wired correctly and well covered so to not cause anything to burn. What I'm not 100% sure of, is whether to add the 2 inline fuses to cover each wire.

The reason for the capacitor is that some people have complained that the LED lights will flicker (although not too bad).

You can see the information in the diagram. I am not an electrician. My primary concern is to protect the engine motor. Everything else can be replaced relatively cheaply.

A very big thank you in advanced.

Comments (14)

  • 11 years ago

    If these LED lights are ones that are designed for automotive or whatever use where they're connected directly to the 12V that's fine. If you're using your own obtained LEDs, they'll probably need some sort of current limiting resistor.

    Only thing I'd change was that I'd put the switch ahead of the BRIDGE (Inline with the fuses).

  • 11 years ago

    Are suggesting adding the switch ahead of the bridge because they are mostly rated VAC (from what I can see)?

  • 11 years ago

    Yes, I know, although I'm thinking it would still work (just a little overkill). I don't have a hardware store that carries these in my area, and a friend one mine happened to have the one mentioned.

  • 11 years ago

    I've closely looked at the existing wiring coming out of the blower, and the AC wires aren't grounded (they go straight from the engine to the existing light)? Would this is normal for a snow blower, or should I assume that it's grounded inside the engine?

  • 11 years ago

    Switches usually have much higher AC ratings than DC ratings.

    My TROYBILT doesn't appear to have the lighting coil connected to the frame at all either. I see no reason that it would need to be bonded to the frame at all.

  • 11 years ago

    You show the existing bulb using 12V. Is that AC or DC? If DC, why not use it instead? If AC, why not use it with a smaller rectifier (Radio Shack)?

  • 11 years ago
    last modified: 11 years ago

    These small gas engines almost always use a lighting coil (since they have no battery to charge they don't need to rectify it to DC. The lightbulb doesn't care.

    By the way, even the incandescent taillight bulb that comes stock on mine flickers.

  • 11 years ago

    So the lighting coil is AC? Or maybe just half wave? Or a pulse like what tickles the spark plug?

  • 11 years ago

    Ron Natalie is correct that the coil produces AC (in my case anyways). I've read that some blowers do have batteries however.

  • 11 years ago

    If the blower has battery start, it may indeed have DC. However, the troy bilt I have uses the household 120V for the electric start or you can pull the rope.

  • 10 years ago

    Maritimer, just wanted to thank you, I installed 2 cree 18 watt lights, and another 10 watt light onto my 28 inch MTD Gold 8.5 HP Snowblower and I followed your diagram exactly and the lights work great. Well Done. Here is a vid I took tonight. Thanks again!! https://youtu.be/-mIkbiztV7o

  • 10 years ago

    That is some serious CP for a snowblower. Now you don't have to worry anymore about injuries or fatalities to small children who might wander into your path :-)

  • 5 years ago

    When I add the capacitors the engine shuts off. Any ideas?