I made a 12volt duck pulsator decoy which works well but i want to put a 12volt DC Wireless receiver and transmitter (Key Fab) in the circuit to turn it on and off by the key fab.

The way i have it rigged up now it stays on the entire time till i unplug one of the wires from the battery. I have a car thermal flasher in the circuit which makes the pump motor pulsate which is what i was going for. The link below will take you to a video to show you what it looks like.

https://www.youtube.com/watch?v=s6enNRHFowA

This is my current set up.
From the pump(Motor) on the decoy the negative wire goes directly to the negative 12volt battery terminal. The positive wire goes to one pole of the thermal flasher. From the other pole of the thermal flasher it is connected to the positive side of the 12 volt battery.

The 12volt DC Wireless Transmitter (Key Fab) and Receiver that i am going to purchase has the following. There are 4 wires coming out the 12volt DC Wireless receiver which there are 2 Yellow Wires and 1 Red Wire and 1 Black Wire. I know the Red and the Black Wires go to the Positive and Negative terminals of the battery as that is how the receiver gets power but i don't know where to connect the two yellow wires in the above circuit to make it turn on and off at the push of the key fab button. Can anyone help?