It is a enabled wire feeder. I just want to use the drive coming out of the motor to drive a tumbler I made to clean scale off of metal parts.

Esab wire feeder.

Esab mig 35

Ah, I had visions of you trying to use the wire spool for the drum.

Here's the manual for that. Page 20 has the schematics. I suspect you need only apply the 120V power to it. You probably may wish to jumper over the inch switch (or put replace it with one that stays depressed).

http://www.esabna.com/eu/literature/arc%20equipment/wire%20feeders/mig%2035_wire_feeder_f-12-786-m.pdf

yes I was wanting to use the speed control. I had an old feeder with a box wired to it that I found on an old welding rotisserie which had a foot pedal that I wedged down with a block of wood and used the speed control on the box but it quit working so now I was wondering if I could just use the wire feeder without the Box to run my Tumblr thank you for your help I will look at that manual and see what I can figure out any other advice would be much appreciated

here's the Box

this is the Box

You need to jumper across the welder trigger input then.

Ok thank you for your help Ron.