gfci issue

12 years ago

I am adding a circuit to a structure. I ran 110v romex from the cb to a gfci which has two outlets and the test buttons and a indicator light, then ran wire from the gfci to an outdoor ourlet. I am getting pwr to the gfci, but the outlets on the gfci don't work nor does the outdoor outlet. I have the pwr attached to the top two screws and the line to the outdoor outlet on the bottom two screws (black/hot on brass screws & white/neutral on silver screws). I have swapped the input wires to the bottom screws and vise/versa and still not power to any outlets. This is a new gfci unit. Suggestions?

Sort by:Oldest

Comments (2)

kudzu9
12 years ago
The load terminal in a GFCI is sometimes opposite of what you expect. I just put in a GFCI that appeared physically identical to another one I installed 2 years ago, but the load terminal positions had been swapped, even though it was from the same manufacturer and looked identical. Did you closely examine the wiring diagram that should have come with the receptacle?

Other thoughts? Have you tripped and reset the GFCI? Have you used a circuit tester to confirm proper wiring? Also, you could have a bum GFCI.

This post was edited by kudzu9 on Sun, Feb 16, 14 at 16:04
User
12 years ago
I noticed that most are "pre-tripped" when energized (orange light on) and you have to reset them. Newer models "fail safe" when the GFCI electronics get zapped and I suspect this behavior is related to that.
Related Professionals
Selma General Contractors · Evansville General Contractors · Concord General Contractors · Fort Dodge General Contractors · Hobbs General Contractors · Idaho Falls General Contractors · Queens General Contractors · Monroe Home Remodeling · Victoria Home Remodeling · Queens Home Remodeling · California Bathroom Remodelers · New Haven Bathroom Remodelers · Portsmouth Bathroom Remodelers · Syracuse Bathroom Remodelers · Denver Bathroom Remodelers