This is a before picture of a of the deck it's going to be removed and a oversized one car garage with sunroom above it with a cantilevered deck.

This picture shows the excavation is started the deck has been removed. Depth is 4’ below grade for the tooting and the foundation.

This picture shows the forms going up for the foundation wall, the footing has already been poured so these forms sit on top of the footing notice the rebar going in between the forms for the new foundation wall. Please note between those two guys there are two anchor bolts being placed with will...

Picture of the anchor bolts that are embedded into the foundation, about 24 are going into this foundation. Placed on the perimeter after the foundation is poured there inserted into the concrete while it is still wet and sticks up just enough to put the sill on.

This picture shows the foundation has been backfilled the garage floor has been backfilled but also compacted. Wire mesh installed for the concrete floor and notice the pinning to the existing foundation of that opening you see is a cut into existing wall which will allow a door way from one garage...

This picture shows the new garage concrete floor has been poured, the floor is actually about 3” higher in elevation in the rear of the garage which allows for water runoff towards the garage door.

This picture shows the sunroom floor going in, we are using engineered I beams for the first floor sunroom above the garage and is also showing the C Channel Steel beams going in for the cantilever deck.

Picture shows exterior wall of the garage with the engineered I Joists for the first-floor sun room along with the C channel steel beams extending out (cantilevered) for the new deck. They cantilever out on the ends 8’ and center bay area about 5 and actually go back into the garage minimum 16’

This is the last of the exterior framing for the exterior along with the installation of the second-floor bay exit out onto the deck

This picture shows the completion of the siding window installation, Carpenters are completing attaching the framing for cantilevered deck to the Steel C Channels, steel brackets were welded to them earlier.

Picture of the bracket welded to the steel C Channel that we attach the deck to.

Picture shows the Fypon railing and balustrade and columns system being installed, the Azek decking was installed prior to the Fypon system.

This home is located in Wellesley, this is the after picture of an oversize one car garage added on to the end of the house and above that we put a sunroom with a cantilever deck.

Framing, Pella window /door installation and rough electric wiring complete, ready for inspection.

This home is located in Wellesley, this is the after picture of an oversize one car garage added on to the end of the house and above that we put a sunroom with a cantilever deck.

This home is located in Wellesley, this is the after picture of an oversize one car garage added on to the end of the house and above that we put a sunroom with a cantilever deck.