SEE HOW CABINETRY BLENDS SO WELL WITH DOOR, TRIM AND BASEBOARDS!.....ANOTHER VIEW OF STOOLS, LIGHT FIXTURES AND HARDWARE.....SINK DEPTH INCREASED 3" (TO 27") WITH 3" CLIPPED CORNERS.....GIVES A LOT OF CHARACTER TO COUNTER TOP.

THINKING AHEAD FOR RESALE, DESK UNIT CAN BE CONVERTED TO BUTLERS PANTRY AS PART OF KITCHEN.....CABS. ARE STD. KITCHEN HEIGHT.....DRAWER IS 24" WIDE AND CAN BE REPLACED WITH BEVERAGE FRIDGE (OUTLET IS FOR FRIDGE WHEN INSTALLED).....WALL CABINETS ENHANCE THE EFFECT.....AGAIN, NOTE HOW CABINETRY TIES...

THINKING AHEAD FOR RESALE.....CURRENT FRIDGE IS 33" WITH A 67" HINGE HEIGHT.....NEW REFR. CAN BE 36" WITH A STANDARD 70" HINGE HEIGHT.....ALL THAT HAS TO BE DONE IS TO REMOVE THE 6" FILLER UNDER THE CABINET AND SLIDE IN THE NEW FRIDGE!

NORMALLY, WALL CABS. JUST END AT WINDOW.....THE CROWN JUST FOLLOWS AROUND TO THE WALL WITH CAN LIGHT IN THE CEILING.....MUCH BETTER FINISHED EFFECT DOING IT THIS WAY.....WE JUST USED STANDARD END PANELS AND TRIM.....IT FRAMES IN WINDOW AND IS FURTHER ENHANCED AS CROWN MOLDING FLOWS ACROSS.

GOOD VIEW OF ANGLE CABINET IN ISLAND.....CABINET TO LEFT IS TRAY-DIVIDER.....DUPLEX OUTLET ON OPPOSITE SIDE.....ALWAYS PUT AT LEAST 1 OUTLET ON END OF ISLAND.

THERE WERE VARIOUS MECHANICALS (ELEC., HVAC, ETC.) INSIDE OLD SOFFITS IN THE CORNER.....TO SAVE COSTS WE LEFT THEM AND CAPPED OFF THE CORNER AT AN ANGLE..... LOOKS GREAT AND SOLVES THE PROBLEM WITHOUT GOING TO GREAT EXPENSE.

STANDARD PROCEDURE TO RUN HVAC THROUGH CABINET TOE KICK.....BE SURE IT RUNS DIRECTLY INTO REGISTER, NOT JUST INTO OPEN AREA IN BOTTOM OF CABINET.