I am attempting to finish the final detail of my basement bar and will need to cut ledgestone panels in about a 2 inch width to cover the final corner of my bar. I was wondering if anyone has a suggestion for how to make the final finished edge look more like natural stone instead of a cut edge.

Should I make the final cuts and then use stone nippers to make the edge appear more normal or just bite the bullet and have the finished edge exposed. It's not an area that will get too much scrutiny. Am I overthinking this and going to be going down a rabbit hole, or can I make the final cut edge look more natural?

I used the manufacturers pre-cut corners for the front but didn't want to waste good corners on this final detail. Obviously I'm past that point now and wanted to solicit input from the experts.