• SEAL GUARD LIQUID WATERPROOFING MEMBRANES QUART
• WaterArmor is a ready-to-use, 100% acrylic-based, fiber-reinforced and liquid-applied air/water resistive barrier.
• SealGuard / WaterArmor can be use as a crack isolation membrane as well
• Ready-Mixed flexible coating that is roll or brush applied directly to approved surfaces to serve as an Waterproofing resistive barrier

Features:

• Provides a barrier resistant to air and water
• Excellent tensile bond
• Ready to use
• Type III air barrier
• Easily applied with brush, roller or trowel

Uses:

• For use as an air/weather resistive barrier over cement boards conforming to ASTM C1325.
• All sheathing joints, terminations, inside and outside corners must be reinforced with SG-4, SG-6, SG-9 or Util-A-Tape REINFORCING FABRIC

Mixing:

• Use directly from original container or prepare in a container that is clean and free of foreign substances. DO NOT USE A CONTAINER THAT HAS CONTAINED OR BEEN CLEANED WITH PETROLEUM BASED PRODUCTS.
• Mix Seal GUARD with a clean, rust free paddle and drill to a homogeneous consistency.
• Note: DO NOT ADD WATER
• Additives are not permitted.
• Clean tools with water immediately after use.

Application:

• Apply to substrates as listed above in "Uses" section.
• Substrate shall be clean, dry and free of release agents, paint or other residue or coatings.
• Apply SealGuard reinforcing fabric to all joints, window and door openings shower pan, niche and seat joints being certain to embed in WaterArmor liquid.
• Note: It is necessary to pre-wet the synthetic roller pad with water and spin out the excess water.
• The pre-wetting only needs to be done once at the start of application. Follow installation instructions for the particular product being installed.