Eased edge

Can I ask what is the difference between Mitred & Straight? that is what is confusing me. I did notice the eased edge is rounded correct? Thanks

Straight edge just refers to that square looking finish that they both offer. The miter refers to the seam on the angled underside while eased is more of a sandwiched look. I’m not sure if there’s prefab countertops in your area but those are all eased with the sandwich seam.

A built-up edge can look every bit as good and often times better than a miter, depending on color, particulates, and movement. People forget that a miter throws the joint right up at your eye, where a built-up edge throws that seam at your waist.

Have your fabricator do a mock-up of each. You may save money and get a better looking edge without mitering.

Remember, the more rounded the edge, the less likely the chipping.

This is what you get with "...clean, square, modern look..." estone edges:

Better get this in the first place, 'cause if I have to re-profile in your home, it's going to be dusty and expensive:

Unless you want the edge to look thicker than the slab, you wouldn't need a seam on an eased edge, right?

Right.

Joseph Corlett, with engineered quartz I’ve never had that kind of chipping issue (knock on wood) with the square edge. I’ve been in the industry for over 15 years now and if it’s installed properly there shouldn’t be any issues

I fix this kind of chipping in quartz constantly.

Hi Christine, we offer either a Ridgeline edge or Rimrock edge. You can see a full list of edge profiles here: https://commercial.cambriausa.com/technical-resources/Edge-Profiles/

Thanks Cambria. With all those sharp 90* at the top, I'm sure to have work for the next four years when I plan to retire.

When choosing a Rimrock edge do I need to do anything special to the cabinet or is the counter built up underneath to make it as thick as the front?

You don't need to change the cabinets. A top installer will provide any needed underlayment.