Why don't you call SZ and find out who delivers them in your area.

It took 3 movers and a dolly to move my over/under 18 yo 550 recently purchased used. I am not positive it was damaged during the move, but the SZ service tech that came out to service it after was concerned that a heat coil under the unit could have been damaged by the dolly. I would defintely get the names of local, authorized repairmen in your area to provide recommendations for the move if they don't provide the moving service themselves. Then, at least you could hire movers and provide specific instructions to them about where to lift and where to avoid. Mine was also on its side for a while and ideally, that should be avoided, from what I understand.

Both good suggestions. I will contact SZ, thanks.

Arlingtonduplex: I did see this mentioned somewhere else about damage underneath the unit. We'll pay attention to that, too.

I'd call a company specializing in moving large safes. They should have the right lifts and dollies.

Call used appliance dealers.

Trying both suggestions for movers. Keeping my fingers crossed that we'll find someone.

Well, found someone finally. Cost more to move than it cost to buy but I can understand that. Thanks for the suggestions. Keep your fingers crossed for an uneventful move this Saturday afternoon.

When you update the post can you let us know who was hired to move the SubZero? :)

I found some office space movers that had a little blurb about appliances in their ad. They have a big enough truck that we don't have to lay it down, which is good. I'll update how the whole thing goes after tomorrow. Cost: 350.00.